Safety Height (units) The height to move to for traverse movements.For example, if pixel size=.006 and the desired step over distance=.015, then use a Step Over of 2 or 3 pixels, because. To find the number of pixels for a given units distance, compute distance/pixel size and round to the nearest whole number. Stepover (pixels) The distance between adjacent rows or columns.Horizontal 'Max background len.' (pixels).Vertical border for cutting background (units, 0=no cutting).The deepest cut into the material is Z=-depth. Depth (units) The top of material is always at Z=0.Down Milling: Start milling at high points, moving towards low points.Up Milling: Start milling at low points, moving towards high points.This reduces the amount of traverse movements Alternating: Start on the same end of the X or Y axis travel that the last move ended on.Negative: Start milling at a high X or Y axis value, and move towards a low X or Y axis value.Positive: Start milling at a low X or Y axis value, and move towards a high X or Y axis value.Scan Pattern Possible scan patterns are:.Plunge Feed Rate (units per minute) The feed rate for the initial plunge movement.Feed Rate (units per minute) The feed rate for other parts of the path.For instance, to mill a 2.5x2.5-inch object from a 400x400 image file, use a pixel size of. Pixel Size (Units) One pixel in the input image will be this many units-usually this number is much smaller than 1.0.Increasing tolerance can lead to better contouring performance in emc, but can also remove or blur small details in the image.
IMAGE TO GCODE CONVERTER SOFTWARE SERIES
Tolerance (units) When a series of points are within tolerance of being a straight line, they are output as a straight line.If “White” or “Black”, then a border of pixels equal to the tool diameter is added on all sides, and details which are at the very edges of the images will not be cut off.
Extend Image Border If “None”, the input image is used as-is, and details which are at the very edges of the image may be cut off.Normalize Image If “yes”, the darkest pixel is remapped to black, the lightest pixel is remapped to white.If “yes”, the black pixel is the highest point and the white pixel is the lowest point. Invert Image If “no”, the black pixel is the lowest point and the white pixel is the highest point.Units Specifies whether to use G20 (inches) or G21 (mm) in the generated g-code and as the units for each option labeled (units).Run image-to-gcode.ry to start the program Settings description The program converts Z-depth map image (.png.
IMAGE TO GCODE CONVERTER SOFTWARE WINDOWS
Image-to-gcode Image-to-gcode for windows and linux without linuxcnc